http://www.corvetteaddiction.com/82ce/forum/ |
|
Newbie - need help getting CE to run http://www.corvetteaddiction.com/82ce/forum/viewtopic.php?f=4&t=616 |
Page 1 of 1 |
Author: | Shawnee [ Sun Nov 28, 2010 7:27 pm ] |
Post subject: | Newbie - need help getting CE to run |
I'm new to a CFI but have gotten alot of information off this site already. Car had been sitting for about 8 yrs. Changed all the fluids, plugs & wires, put in new fuel pump & filter and it started. Increase the fuel pressure to 13 psa and balanced the TB and ran pretty good but found out I needed to rebush them. Seemed to run pretty good after the rebush but decided to change the dist cap and rotor since it still seemed to run a little rough at low rpm. My trouble seemed to start after that. Put on a new MSD cap and rotor and the car would hardly run. Put the old cap & rotor back on and runs a little better but still not right. Car wants to idle about 1500 to 2000 rpm (this was set at 500 earlier after the rebush). It then all of a sudden dumps a bunch of fuel in and almost kills the engine. I had used WinAldl earlier (before rebush) and did not get any error codes. Now I'm getting MAP pressure low and coolant temp low. Car was fully warmed up when I was testing. Pulled the cap and rotor and checked the wires and all looked good. I have not used WinAldl before so I'm not sure as to what I should be looking for. Any help would be appreciated as I'm trying to bring her back from the dead. |
Author: | dj_miller [ Mon Nov 29, 2010 1:28 pm ] |
Post subject: | Re: Newbie - need help getting CE to run |
For crossfire questions, I have found The Crossfire Injection Vault (http://www.crossfire.homeip.net/) to be an excellent web site. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |