http://www.corvetteaddiction.com/82ce/forum/ |
|
| break question http://www.corvetteaddiction.com/82ce/forum/viewtopic.php?f=4&t=613 |
Page 1 of 1 |
| Author: | basecar [ Fri Oct 22, 2010 6:53 am ] |
| Post subject: | break question |
Bled the brakes, changed one caliber, have a hard pedal when the CE is not on/running. When running the pedal goes to the floor. Anyone have that same problem, what causes it, what to do. |
|
| Author: | vette_guy [ Sun Nov 21, 2010 10:26 pm ] |
| Post subject: | Re: break question |
This is a typical sign of a master cylinder issue -OR- air in the lines. If you let out enough fluid it might be possible that an air bubble was introduced int the system. Recommend thoroughly bleeding the system. Mark |
|
| Author: | basecar [ Mon Nov 22, 2010 7:58 am ] |
| Post subject: | Re: break question |
Thanks, I finally did that. Used about a gal of break fluid. Flushed all the lines got out all the old stuff. Couple of things I learned was used a vaccum pump, worked really well. Took a rubber mallet and tapped on the calipers to get the air up to the bleeding screws. Breaks have been good since. No problems. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|